Roland DGA Firmware Updater Application
User Instructions 1/2006 

1. Turn the main power of the unit on. (This power switch will be located near the power cord.) 

2. Hold down the up, left and down arrow keys while pressing the sub power button to enter the Firmware Upgrade mode. (The sub power button is found on the front panel of the printer.) 

3. The printer will display version up are you sure; press the enter key. 

4. The display will then read waiting indicating it is ready to receive firmware. 

5. Launch the Roland Firmware Upgrader.exe application. 

6. Enter the units TCP/IP address and then click Next. If this is a SP-300 or SP-300V unit, select SP-300 in the menu next to the option to Output though a Windows Driver. 

7. Click Next 

8. Click Yes 

9. The Roland Firmware Updater Application will start to transfer the firmware to the unit. 

10. Click Finish to close the application. 

11. The Roland units display will show erasing then writing and then complete. 

12. Once the display reads complete you may then power down the unit and restart it. 

13. Make sure when the printer powers back up to check the firmware version to confirm that it was completely installed. 

14. You have now completed the firmware upgrade.

**If problems arise during firmware updating or if you have any questions on this procedure, please contact your local Roland DGA Authorized Reseller or Roland DGA Technical Support (800-542-2307). Thank you
